side jamb การใช้

• Sometimes the header jamb or side jambs get skewed, jamming the door.
• Look at the gap between the shutters and the side jamb.
• A . Yes, and nailing into the hinge-side jamb is not one of them.
• There are no hinges at the side jambs.
• Be sure to check the gap at both side jambs before attempting to install the shutters.
• The contractor nailed into the hinge-side jambs to try to make the doors and doorways vertical.
• The weights are concealed in cavities ( called side jambs ) on the sides of the window.
• You may have to wedge both side jambs and the top one to square up the frame.
• Two shutters will be hinged together and attached to the left side jamb, the other two to the right side.
• You can't renail the side jambs to the threshold, but you can caulk the joints where the jambs set on the threshold.
• Cut it in half cross-wise, and pry the pieces out; it will take some wiggling, because the threshold is probably nailed to the side jambs.
• And finally, fill in the gap in the side jamb created by the thinner head jamb with a sliver of wood or bit of wood filler.
• The new threshold may be thinner than the old, so to accommodate that thinness, put some shims under the threshold so it butts tightly against the bottom of the side jambs.
• There is no standard method for constructing the arch frame, but it must be sturdy, firmly attached to the header and side jambs, and provide sufficient nailing surfaces to attach the drywall.
• In the side jambs are carved six figures, after the rest of the portal, four of which represent Moses, Aaron, Saint Peter and Paul the Apostle; the other two are not easily identifiable.
• If you do take off the casing and baseboards and put in new drywall and then put the casing and baseboards back on, you will have to adjust the side jambs and side stops of all windows and doors.
• One more thing : Also nail near the inner side of the casing board and at a slight angle so the nail goes into the edge of the side jamb . ( The side jamb is the board actually in the opening; the door hinges are attached to one side jamb, the latch on the other .)
• One more thing : Also nail near the inner side of the casing board and at a slight angle so the nail goes into the edge of the side jamb . ( The side jamb is the board actually in the opening; the door hinges are attached to one side jamb, the latch on the other .)
• One more thing : Also nail near the inner side of the casing board and at a slight angle so the nail goes into the edge of the side jamb . ( The side jamb is the board actually in the opening; the door hinges are attached to one side jamb, the latch on the other .)